18 - Nov - 2026

Please stop cleaning only your dryer’s lint trap. The vent is where the fires start

I clean the lint screen in the dryer after every load of laundry, just like nearly everybody else I know. But the part almost nobody cleans is the 4-inch duct that exhausts the heat and moisture from the dryer itself. Newer gas dryers shut themselves off, telling you that you need to clean the dryer vent. In older ones, a clogged exhaust could lead to a fire even though the lint screen was clean. The U.S. Fire Administration estimates that there are about 2,900 home dryer fires per year, and the main factor is lack of cleaning.

The lint screen only catches part of the lint

What gets past it settles in the duct

The lint screen on the dryer is a coarse filter and some of the fine lint and fibers will make it past that screen. That lint will then travel in the air as it is exhausted from the dryer and get deposited in areas where that air slows down. These areas include the cavity under the lint screen, the back of the dryer and all of the elbows in the duct and the hood outside the house. I found out that my lint screen was not catching all the lint with a $9 vacuum attachment I bought to clean the vent.

The path for the lint in my dryer vent has lots of places where it can deposit itself. The dryer vent starts on the first floor and travels down to the basement. It has two elbows and travels across the basement between the floor joists and then makes a left and then a right to exit the house from the side. This is a total of four elbows and about 22 feet of duct.

The building code, assuming you follow the model building code, allows for a maximum dryer vent length of 35 feet and each tight 90 degree elbow takes away 5 feet of that length (unless the dryer manufacturer’s chart says you can have a longer duct). With four elbows, 20 feet of that length is gone.

A clogged vent leaves the heat nowhere to go

Restricted airflow is what raises the temperature

A dryer is essentially an air flow machine. It uses a burner or element to heat the air and the blower moves that air around the clothes and then exhausts it outside. If the outlet for this air is restricted, the air volume that the same heat is transferred to gets reduced and the dryer runs hotter. It’s similar to a furnace with a restricted air filter. I spent 12 years in the HVAC industry and a lot of equipment failures can be traced to low airflow.

And of course, the lint is fuel. The U.S. Fire Administration statistics state that dust, fiber, and lint are the most likely items to be ignited first in a dryer fire (28%). Gas dryers also have the additional risk of exhausting carbon monoxide and other combustion gases. If the vent is blocked, the possibility exists for those gases to get back into the home. This dryer is one of 6 gas appliances in my home, and I take that seriously.

The warning signs show up long before a fire

Longer cycles, a hot laundry room, and a flap that barely opens

4 inch dryer vent duct between basement joists Credit: Jonathon Jachura / MUO

There are several signs that your dryer vent is getting restricted. Dryer cycles take longer to complete, the top of the dryer and the laundry room feels warm, and the exhaust flap on the outside dryer hood does not open much when the dryer is running. Some dryers, including mine, will also shut down and display a warning to clean the dryer vent. If you get this message, believe it.

Look outside when the dryer is running and you should see a good amount of air coming out of the dryer vent, it should feel warm and the exhaust flap on the dryer hood should open up. Birds and other small critters like the dryer vent too, so make sure there is no nesting going on.

Clean what you can reach, then know your limit

Both ends are a DIY job, and the middle may not be

When the dryer shut itself off, I vacuumed the lint cavity from the dryer with the vacuum attachment. Then I moved the dryer away from the wall and vacuumed the back of the dryer and the duct that connects to it. I also went outside and vacuumed the lint out of the dryer vent hood. It seems to be blowing fine.

There is only so much that I can get with the vacuum from both ends of the dryer vent. Prior to putting a ceiling in the basement, I took apart the dryer duct at the elbows and visually inspected inside. Then I reinstalled the elbows. It looked good. I trust the middle of the vent now that I’ve done this visual inspection.

For a longer dryer vent like mine, a professional with a rotary brush should be the next step. It will cost about $100 to $200. My neighbor recently got estimates, and they received three quotes and took the middle quote, which ended up costing around $150. Fire officials recommend cleaning the dryer vent once a year, or more often if dryer cycles start taking longer.

Do it before January

It’s time to clean the dryer vent now. Dryer fires are more common in the fall and winter months, with a peak in January. Clean the lint screen, use the vacuum attachment to clean the lint cavity, move the dryer from the wall to clean the duct, and go outside and check the dryer vent hood. If your dryer vent is made of foil or plastic, replace it with a rigid metal duct. And if your dryer gives you a warning to clean the dryer vent, do it before your next load of laundry.

Leave a Reply

Your email address will not be published. Required fields are marked *